MB Vise Versagrip Jaw Inserts

The Sherline MB Vise Fixture is designed to locate directly in the T-slots of our mill tables and tooling plates. By aligning the fixed and movable jaws in the T-slots, your mill table or tooling plate becomes the base for the fixture—maximizing usable table length. This setup allows you to securely hold and machine much larger or irregularly shaped parts than traditional vises can accommodate.

Workholding Versatility

The MB Vise Fixture supports a wide range of part shapes through the use of two different sets of interchangeable top jaws:

For square and rectangular stock use the standard top jaws with either:

• Talon Grip Vise Jaw Inserts (P/N 35526) by Mitee-Bite

• Reversible Jaw Inserts (P/N 35524) (smooth/serrated) by Saunders

For round or irregularly shaped material:

Use the MB Versagrip Top Jaws (P/N 35535), which fit the same fixed and movable base plates. These jaws accept the MB Versagrip Vise Jaw Inserts (P/N 35529) by Mitee-Bite. The ¾" round inserts can be rotated within any insert pocket to match and grip a wide variety of part geometries securely.

Standard MB Vise Fixture Includes:

• Fixed base plate

• Movable base plate

• Adjustable stop

• 3 hex keys (7/32", 5/32", 3/32")

• Mounting screws and T-nuts

Insert Options:

• P/N 35524 – Reversible Jaw Inserts:
  One side is serrated for gripping raw stock, and the other is smooth for holding finished parts with minimal marking. Easily reversible in the top jaw (includes 1 insert and 4 screws).

• P/N 35526 – Talon Grip Vise Jaw Inserts:
  Double-sided serrated inserts for aggressive holding of raw stock. The serrated edge enhances grip strength (includes 2 inserts and 2 screws).

• P/Ns 35535 & 35529 – MB Versagrip Vise Jaws & Inserts:
  Serrated on both sides for secure gripping of raw or irregular material. Compatible only with the Versagrip jaws (includes 4 inserts and 4 screws).

• P/N 35528 – MB Hard Stop:
  Designed to fit in the fixed jaw insert slot and used alongside the Talon Grip Inserts (P/N 35526) for repeatable part positioning.

Notes:

• Jaw inserts are sold separately. The Standard MB Vise Fixture Base Plates are required to mount any jaw inserts.

• Although the serrated inserts are intended for raw stock, they may be used on finished surfaces if light clamping pressure is applied and only light machining or engraving is performed.